510098 Bearing

510098 Bearing

Maintenance of automobile wheel hub bearings Before disassembling the wheel hub, preparations for wheel hub maintenance should be made, and the vehicle should be stopped and erected to ensure the safety of maintenance work.

510098 bearing

OE: 510098

Interchange Part number: DAC48860042/40-RZ-ABS(96G)

Fitting Position : Left

Fitting Position : Right

Supplementary Article/Info 2 : with integrated magnetic sensor ring

Inner Diameter : 48mm

Outer diameter : 86mm

Width : 42mm

Width 2 [mm] : 40mm

Quality: High level

Warranty: 12 Months

Certificate: ISO/TS16949

Place of Origin: China (mainland)

 

Application:

HONDA  ACCORD VII (CL, CN) 2.0 (CL7)                         2003-2008

HONDA  ACCORD VII (CL, CN) 2.0 All-wheel Drive (CL8)           2003-2008

HONDA  ACCORD VII (CL, CN) 2.2 i-CTDi (CN1)                  2004-2008

HONDA  ACCORD VII (CL, CN) 2.4 (CL9)                         2003-2008

HONDA  ACCORD VII (CM) 2.4 Vtec E (CM5)                      2002-2005

HONDA  ACCORD VII (CM) 3.0 (CM6)                             2003-2005

HONDA  ACCORD VII Tourer (CM, CN) 2.0 (CM1)                   2003-2008

HONDA  ACCORD VII Tourer (CM, CN) 2.2 i-CTDi (CN2)             2004-2008

HONDA  ACCORD VII Tourer (CM, CN) 2.4 (CM2)                   2003-2008

HONDA  ACCORD VII Tourer (CM, CN) 2.4 Vtec T                   2003-2008


Maintenance of automobile wheel hub bearings Before disassembling the wheel hub, preparations for wheel hub maintenance should be made, and the vehicle should be stopped and erected to ensure the safety of maintenance work. (1) Remove the decorative cover and dust cover of the hub axle head; (2) Remove the tire nut and tire, taking care not to hurt the thread of the tire bolt. In the case of a disc brake, the brake should be removed and used to remove the lock ring or pin. (3) Remove the hub with special tools; (4) Scrape off the old grease in the bearings, journal and hub cavity, clean the hub bearing and journal with a cleaning agent and wipe dry with a cloth, and finally clean the hub cavity with a cloth . (5) Inspect the hub bearing and bearing race. If cracks, fatigue peeling, or loose bearing rollers are found, the bearings should be replaced. If pitting is found on the bearing race, the bearing should also be replaced. (6) Check the fit between the bearing's inner diameter and the journal. When measuring the journal clearance, it should be measured at the upper and lower parts of the vertical ground (the largest wear part). If the fit clearance exceeds the specified use limit, the bearing should be replaced to restore the normal fit clearance. Burrs and pits on the journal are not allowed to reduce the gap. (7) After all parts meet the requirements, apply grease to the inner bearing and place it in the wheel hub.

510098 bearing


Previous: Wheel Bearing 510102

Next: 510087 Bearing