Wheel Bearing Kit For Ford Mondeo VKBA3576
Wheel hub bearings
wheel hub bearing is a component used to support and provide accurate guidance for the rotation of the hub at the axle of a car. It is an important part of the load and rotation of a car.
Wheel hub bearing is one of the key parts of the car. Its main role is to carry the weight and provide accurate guidance for the rotation of the hub. This requires that it can withstand not only axial load but also radial load.
FORD MONDEO III (B5Y) 1.8 16V CGBA,CGBB 1798 81 4 Hatchback 2000-2007
FORD MONDEO III (B5Y) ST220 MEBA 2967 166 6 Hatchback 2002-2007
FORD MONDEO III Saloon (B4Y) ST220 MEBA 2967 166 6 Saloon 2002-2007
FORD MONDEO III Turnier (BWY) ST220 MEBA 2967 166 6 Estate 2002-2007
JAGUAR X-TYPE (X400) 2.0 D FMBA,FMBB,R4-X404 1998 96 4 Saloon 2003-2009
JAGUAR X-TYPE Estate (X400) 2.0 D FMBA,FMBB,R4-X404 1998 96 4 Estate 2004-2009
Common abnormal noise problem
When one of the four wheel bearings of the vehicle is damaged, you will hear a continuous humming sound in the car while driving. This sound can't tell where it came from, and it feels like the whole car is inside. It is full of such snoring, and the faster the speed, the louder the sound. The following is the judgment method:
Method 1: Open the window to hear if the sound comes from outside the car;
Method 2: After increasing the speed (when the noise is loud), the gear position is in the neutral position to let the vehicle slide, and observe whether the noise comes from the engine. If the noise does not change when the neutral gear slides, most of the wheel bearings have problems;
Method 3: Temporarily stop, get off and check if the temperature of the axle is normal. The method is: touch the four hubs by hand and feel the temperature is consistent. (When the brake shoes and the gap are normal, the temperature of the front and rear wheels is If there is a gap, the front wheel should be high. If you feel that the difference is not big, you can continue to drive slowly to the repair station;
Method 4: Raise the car with a lift (previously release the handbrake and hang the neutral). When there is no lift, the jack can be used to raise the wheel one by one. The manpower will rotate the four wheels quickly. When the problematic axle is encountered, it will be issued. The sound is completely different from other axles. It is easy to tell which axle has a problem with this method.
If there is severe damage to the hub bearing, there are cracks, pitting or ablation on it and must be replaced. Apply grease before loading new bearings, and then install them in reverse order. The replaced bearings must be flexible and free of miscellaneous and vibration.