Wheel Bearing Kit For RENAULT ESPACE Rear Axle VKBA3609

Wheel Bearing Kit For RENAULT ESPACE Rear Axle VKBA3609

Wheel Bearing Kit For RENAULT ESPACE VKBA3609 OE: 820064935, 402020003, 770120823 Interchange Part number: 71363096, VKBD103, KF15583 Size: Rear Axle Width: 48 mm Inner Diameter: 30 mm Outer diameter: 62 mm Quality: High level Warranty: 12 Months Certificate: ISO/TS16949 Place of Origin: China...

Wheel Bearing Kit For RENAULT ESPACE VKBA3609

OE: 820064935, 402020003, 770120823

Interchange Part number: 71363096, VKBD103, KF15583

Size: Rear Axle

Width: 48 mm

Inner Diameter: 30 mm

Outer diameter: 62 mm

Quality: High level

Warranty: 12 Months

Certificate: ISO/TS16949

Place of Origin: China (mainland)

Application:

RENAULT CLIO IV (BH_) 1.6 RS 2013-

RENAULT ESPACE IV (JK0/1_) 1.9 dCi (JK0U) 2003-2005

RENAULT GRAND SCÉNIC II (JM0/1_) 2.0 2004-

RENAULT LAGUNA II (BG0/1_) 1.9 dCi 2001-


Duhui is a professional manufacturer and supplier of wheel bearings, and we focus on developing all kinds of wheel bearing kits.


Bearing installation method

The bearing should be installed according to the bearing structure, size and the matching nature of the bearing components. The pressure should be directly applied to the end face of the ferrule, and the pressure should not be transmitted through the rolling elements.

Press fit

The inner ring of the bearing is tightly matched with the shaft. When the outer ring and the bearing housing hole are loosely fitted, the bearing can be press-fitted on the shaft first, and then the shaft is fitted into the bearing housing hole together with the bearing. On the end face of the bearing inner ring, the gasket is made of a soft metal material (copper or mild steel). The inner diameter of the assembly sleeve should be slightly larger than the diameter of the journal. The diameter of the outer diameter should be slightly smaller than the inner ring of the bearing to avoid Press on the cage. The bearing outer ring is tightly matched with the bearing housing hole. When the inner ring and the shaft are loosely fitted, the bearing can be first pressed into the bearing housing hole. At this time, the outer diameter of the assembly sleeve should be slightly smaller than the diameter of the housing hole. If the bearing ring and the shaft and the seat hole are tightly fitted, the inner ring and the outer ring should be pressed into the shaft and the seat hole at the same time, and the structure of the assembly sleeve should be able to simultaneously tighten the end faces of the inner ring and the outer ring of the bearing. 01(001)

02(001)

03(001)

04(001)