Ford Edge Wheel Hub Assembly 7T4Z1104C

Ford Edge Wheel Hub Assembly 7T4Z1104C

Ford Edge Wheel Hub Assembly 7T4Z1104C Fitting Position: Right Fitting Position: Left Fitting Position: Rear Axle FORD EDGE 2007-2010 LINCOLN MKX 2007-2010 First of all, we need to use the circlip pliers to hook out the rotten bearing seals and balls inside, and then clean them. Next, use the...

Ford Edge Wheel Hub Assembly 7T4Z1104C

 

Fitting Position: Right

Fitting Position: Left

Fitting Position: Rear Axle

 

FORD EDGE 2007-2010

LINCOLN MKX 2007-2010

 

First of all, we need to use the circlip pliers to hook out the rotten bearing seals and balls inside, and then clean them.

Next, use the bearing special tool puller to pull out the outer diameter of the bearing on the car.

Secondly, we will install the new bearing. When installing, we must pay attention to the size of the steel pipe. The size of the steel pipe should be the same as the inner diameter of the bearing. The inner diameter must be tapped during the installation process. If the outer diameter bearing is hit, it will be easily damaged. It is important to note that when we are installing new bearings, we must not touch the butter because the crude oil of the manufacturer is the best. Then knock the bearing down. This is the case if the bearing is mounted on the upper half shaft.

Again, we apply the butter to the semi-axle and mount it on the wheel, where we need to tap the outer circle of the bearing and tap it in. Then install the circlip and use the circlip pliers to insert the circlip into it. The circlip on the outside and the bearing must be tightened.

Finally, pay attention to the points of attention during the installation of the bearing:

1. It is not necessary to apply butter when installing the bearing. The original butter is the best.

2. When installing the bearing, it is necessary to use the steel pipe to hit the inner diameter of the bearing and install it.

3. When installing the half shaft, it is necessary to use the steel pipe to hit the outer diameter of the bearing for installation.

4. Both the circlip on the bearing and the circlip on the outside of the semi-axle need to be clamped with circlip pliers.

Ford Edge Wheel Hub Assembly 7T4Z1104C