Wheel Hub Assembly For Ssangyong 4242035000

Wheel Hub Assembly For Ssangyong 4242035000

Wheel Hub Assembly For Ssangyong 4242035000 Fitting Position: Rear Axle Specification: 2WD Specification: MOYEUX SSANGYONG TIVOLI 1.6 G16DF 1597 94 4 Closed Off-Road Vehicle 2015- SSANGYONG TIVOLI 1.6 XDi 160 D16DTF 1597 85 4 Closed Off-Road Vehicle 2015- First of all, we need to use the circlip...

Wheel Hub Assembly For Ssangyong 4242035000

 

Fitting Position: Rear Axle

Specification: 2WD

Specification: MOYEUX

 

SSANGYONG  TIVOLI 1.6 G16DF 1597 94 4 Closed Off-Road Vehicle 2015-

SSANGYONG  TIVOLI 1.6 XDi 160 D16DTF 1597 85 4 Closed Off-Road Vehicle 2015-

 

First of all, we need to use the circlip pliers to hook out the rotten bearing seals and balls inside, and then clean them.

Next, use the bearing special tool puller to pull out the outer diameter of the bearing on the car.

Secondly, we will install the new bearing. When installing, we must pay attention to the size of the steel pipe. The size of the steel pipe should be the same as the inner diameter of the bearing. The inner diameter must be tapped during the installation process. If the outer diameter bearing is hit, it will be easily damaged. It is important to note that when we are installing new bearings, we must not touch the butter because the crude oil of the manufacturer is the best. Then knock the bearing down. This is the case if the bearing is mounted on the upper half shaft.

Again, we apply the butter to the semi-axle and mount it on the wheel, where we need to tap the outer circle of the bearing and tap it in. Then install the circlip and use the circlip pliers to insert the circlip into it. The circlip on the outside and the bearing must be tightened.

Finally, pay attention to the points of attention during the installation of the bearing:

1. It is not necessary to apply butter when installing the bearing. The original butter is the best.

2. When installing the bearing, it is necessary to use the steel pipe to hit the inner diameter of the bearing and install it.

3. When installing the half shaft, it is necessary to use the steel pipe to hit the outer diameter of the bearing for installation.

4. Both the circlip on the bearing and the circlip on the outside of the semi-axle need to be clamped with circlip pliers.

Wheel Hub Assembly For Ssangyong 4242035000

Previous: No Information

Next: Ssangyong Rexton Wheel Hub Assembly 4142009701