TOYOTA Sequoia 2001-2007 Wheel Hub Assembly

TOYOTA Sequoia 2001-2007 Wheel Hub Assembly

The disassembly of the bearing is carried out on a regular basis and the bearing is replaced. After disassembly, if you continue to use it, or if you need to check the condition of the bearing, the disassembly should be carried out as carefully as the installation.

Rear Wheel Hub for TOYOTA Sequoia 512211


Rear Axle

Bolt Circle Diameter: 5.51 In.

Wheel Pilot Diameter: 1.9 In.

Hub Pilot Diameter: 3.7 In.

Hub Bolt Circle Diameter: 5.4 In.

Bolt Quantity: N/A

Bolt Hole MET: 12.00

Bolt Hole qty: 4

ABS Sensor: No

Number of Splines: N/A


Application:

TOYOTA Sequoia 2001-2007


Maintenance

Disassembly

The disassembly of the bearing is carried out on a regular basis and the bearing is replaced. After disassembly, if you continue to use it, or if you need to check the condition of the bearing, the disassembly should be carried out as carefully as the installation. Attention should not damage the bearing parts, especially the disassembly of the interference fit bearing, which is difficult to operate.


It is also important to design and manufacture disassembly tools as needed. When disassembling, study the disassembly method, sequence, and investigation of the fitting conditions of the bearing according to the drawings, so as to obtain the foolproof operation.


To remove the interference fit outer ring of the outer ring, install a few outer ring extrusion screw screws on the circumference of the outer casing, and tighten the screw evenly while disassembling. These screw holes are usually covered with a blind plug, a tapered roller bearing, etc., and a plurality of slits are provided on the shoulder of the outer casing, and the spacer is used, disassembled by a press, or gently tapped and disassembled.


The removal of the inner ring is the easiest to pull out with a press. At this time, pay attention to let the inner ring withstand its pulling force. Moreover, the pull-out fasteners shown are also mostly used, and regardless of the type of fixture, they must be firmly stuck on the side of the inner ring. To do this, consider the size of the shaft shoulder or study the groove at the shoulder to use the pull fixture.


01(001)

02(001)

03(001)

04(001)